Forum Discussion

balinta01's avatar
balinta01
Occasional Contributor
13 years ago

Busy Objects

Hi all, I have prepared a distributed testing however I usually get an error message on the slave computer (in a job when slave and master runs parallel), which says "Unable to perform this act...
irina_lukina's avatar
irina_lukina
Super Contributor
13 years ago

Hi Attila,


Most likely, you were trying to run a network suite when it was already running. For instance, the following (or similar) code might be used:



NetworkSuite.Run(false);

NetworkSuite.Run(false);


To avoid such problems, I recommend that you check whether the network suite's run is over before running it again from your test. For instance, you can use the following code:



NetworkSuite.Run(false);

NetworkSuite.WaitForState(ns_Idle);

NetworkSuite.Run(false);


I hope, this information helps :)