Forum Discussion

ml's avatar
ml
Contributor
10 years ago

Starting distributed testing with commandline?

Hello,

is it possible to start a network suite job over the commandline?

  • Have you reviewed the TestComplete Command Line support article? To run your NetworkSuite job, from the TC IDE, select /open the project containing the NetworkSuite job you wish to run. With the project visible in the Workspace in the right pane,

    Note that the control labled 'New Test Item' which will allow you to add/configure a new test item that 'ponts' to/references the NetworkSuite job, that you want to run. Once that is completed, you can then pass the applicable parameters from the command line (/project:project_name  /projectitem:item_nam)

  • Have you reviewed the TestComplete Command Line support article? To run your NetworkSuite job, from the TC IDE, select /open the project containing the NetworkSuite job you wish to run. With the project visible in the Workspace in the right pane,

    Note that the control labled 'New Test Item' which will allow you to add/configure a new test item that 'ponts' to/references the NetworkSuite job, that you want to run. Once that is completed, you can then pass the applicable parameters from the command line (/project:project_name  /projectitem:item_nam)